Back to Blog
How-to Guides 2026-11-16 Partyrama 0 views

How to Hang a Moana 2 Bunting Banner: 2.3m Paper Flag Guide

How to Hang a Moana 2 Bunting Banner: 2.3m Paper Flag Guide

Plan and hang the Moana II Sailing Spirit paper triangle flag bunting with a clear 2.3m layout, knot-and-sag technique, and indoor placement ideas for a Moana birthday party.

Start with the 2.3m span and nine flags

The Moana II Sailing Spirit paper triangle flag bunting is a single 2.3m / 7.6 ft strand carrying 9 pennants printed on both sides. Each flag measures 18cm / 7.1 in long and 25cm / 10 in high. Those numbers decide where it fits: the strand is short enough for one doorway, a dessert table backdrop, or a single wall, and the 25cm flag height means you need clear vertical space above the fixing points so the points do not sit behind furniture or a door frame.

Because the flags are paper, plan the hang before you tie anything. Paper bunting is lightweight and easy to hang, but it is not built for outdoor weather or tight, high-tension spans. Keep it indoors unless the supplied information confirms otherwise, and treat the strand as a decorative span rather than a structural line.

Measurements to check before you drill or stick anything

A simple hanging sequence for a paper triangle flag bunting

Work from the middle outward so the flags stay evenly spaced and the strand does not twist.

  1. 1. Choose two fixing points about 2.3m apart: Measure the wall, doorway or table front and mark two points that give the full strand room. If the gap is shorter, the bunting will sag or the flags will overlap; if it is longer, you will need to tie off the excess rather than stretch the paper.
  2. 2. Set the height with the 25cm flags in mind: Allow at least the flag height below the hanging line so the triangle points hang free. Check that door swings, cupboard handles and table decor will not catch the paper points.
  3. 3. Unpack and separate the flags: The bunting arrives in cardboard packaging. Unroll or unfold the strand gently on a clean surface and let the paper flags settle before you lift it, so creases do not become permanent.
  4. 4. Tie one end with a simple knot: Loop the strand end around your fixing point and tie a knot you can undo. Leave a small tail so you can adjust tension without untying the whole banner.
  5. 5. Support the middle before tying the second end: Hold or temporarily hook the middle of the strand at the height you want. This stops the paper flags dragging on the floor while you work and helps you judge the sag.
  6. 6. Tie the second end and adjust the sag: Tie the loose end, then slide the knots or add a small loop to raise or lower the strand. A gentle curve looks intentional; a deep V pulls the flags together and hides the Moana designs.
  7. 7. Fan the flags and check both sides: The pennants are printed on both sides, so turn any twisted flags face-out and space them evenly along the strand. Step back to check the banner reads clearly from the party side of the room.

Placement ideas for a Moana birthday party

The 2.3m length suits one clear focal span rather than a room-wide swag. These placements use the strand without asking it to do more than paper can.

  • Across a dessert table backdrop: Tie the bunting between two wall hooks above the cake table, keeping the 25cm flags clear of the tabletop. The Moana-themed designs sit behind the cake rather than competing with it.
  • Over a doorway or party entrance: A 2.3m strand fits a standard doorway span with a little slack. Fix it above head height so the paper points do not brush hair or get caught as guests walk through.
  • Along one wall behind the food table: Use two removable hooks at the same height and let the banner run straight. This keeps the paper flat against the wall and avoids the flags curling away from the designs.
  • As a photo-backdrop top line: Hang the bunting as the top edge of a photo area and keep the rest of the backdrop simple. The pennants are printed on both sides, so they still look right if the photo angle changes.

What this bunting does not confirm

The supplied information does not list a hanging cord, adhesive strips or wall fixings, so check what is in the cardboard packaging before you plan your fixing method. It also does not confirm outdoor suitability, fire treatment or reusability after a party. Treat the paper flags as single-event decor unless you can store the strand flat and dry between uses.

If you need a longer run than 2.3m, this single strand will not cover it on its own. The catalog lists the Moana II Sailing Spirit bunting as a single banner, so plan one focal span or source additional strands rather than stretching the paper.

Related Articles

Customer Service
Home
Products
Cart
Profile